HOW TO USE

BEFORE TREATMENT

Cleanse your skin so that it is clean, dry and free of make-up. Then choose a suction head. For your first treatment, we recommend the diamond head.

Switch the device on at the lowest suction setting and try it on the back of your hand first. This lets you practise the angle and movement before you use it on your face. Wait 5 minutes to see how your skin reacts before you carry on.

You can steam your face before treatment to open and relax the pores. Use a facial steamer, or hold your face over the steam from a bowl of hot water for 5-10 minutes. This step is optional.

DURING TREATMENT

The device has 4 suction levels. For your first treatment, it is important to use only the lowest, and therefore gentlest, level. In later treatments you can increase the suction little by little. One exception: if you want to remove blackheads around the nose with the small suction head, you can use level 3-4.

Glide the device gently along the natural lines of your face in quick, smooth strokes. Do not go over the same area more than 2-3 times, and do not hold the device in one place for several seconds.

Stop the treatment if it hurts. Pain can mean the suction is too strong, the device has stayed in one place for too long, or an area has been treated too much.

AFTER TREATMENT

Remove the suction head and clean it with water, and a cotton bud if needed. We also recommend disinfecting the suction head.

Rinse your face with cold water to close the pores and soothe the skin. It is important to keep your skin well moisturised, so finish with your usual face cream or mask.

Notice how your skin responds after each treatment and adjust the next one to suit it.